Noise

Everyone "knows" that water cooling is quieter than air cooling. We have been told that for years - so much so that many enthusiasts no longer question this idea. That is certainly true when comparing water cooling to the small, loud fans on air coolers of the past. However, the current top heatpipe towers use large, high-output, low-noise fans for cooling and it is time again to challenge conventional wisdom based on out-of-date "facts".

For many enthusiasts upgrading cooling, the goal is maximum stable overclock, and they will live with the inconvenience of a louder system. For other users silence is the most important factor, and these users will forgo maximum overclocking if that increases system noise levels. That is why many who value silence choose water cooling.

Noise Level - 6

Noise Level - 24

The belief was that water cooling noise levels would be so low that pages would be required to detail the lower noise levels of our new cooler test bed in complete detail. Once again we're totally shocked that these two cooling kits from major players using top water cooling components are among the noisiest cooling systems tested so far at AnandTech.

Assuming something must be wrong with our results or the 120mm fans in the water cooling kits, we tested many times and got the same results. Where then, does the 45-46 dB(A) noise come from at 24", when the system noise floor is 38.3 dB(A) on the old test bed and much lower on the new cooling test bed? What is generating the 52.3 to 52.5 dB(A) noise at 6" where the system noise floor is worst case 47 dB(A) and the new test bed is even lower?

It turns out the noise culprit is the water pump on both systems. Measured noise at 24" with the pump and fan running was around 46 dB(A) on the Swiftech, where noise level with the pump only and the fan disconnected for a short time was 45.5 dB(A). Results with the Nautilus were similar, proving the offender in noise is the water pump. With pump noise so high it was pointless to test the fan at lower voltage since it was only adding 0.5 dB(A) at full speed and highest noise.

It is very important, however, to talk about perceived noise. The water coolers measure very high noise levels, but the noise frequencies are not particularly irritating. The pump noise is a low hum instead of a high-pitched scream and most users would rate the noise as audible, but not particularly annoying.

There is also the comparison of the internal mount water pump on the Swiftech H2O-120 Compact and the external mount water pump on the Corsair Nautilus 500. Our test method with the open case side is the worst possible noise you can get with the Swiftech. If you close the case side the noise drops about 5 dB(A) with the Swiftech, which is much quieter but not silent or competitive with the best heatpipe towers using high-output low noise fans. The Corsair external cooler noise, on the other hand, is what you get. There are no noise producers inside the case that can be damped with a Corsair external water cooler install.

Cooling at Stock Speed Scaling of Cooling Performance
Comments Locked

58 Comments

View All Comments

  • psychotix11 - Monday, September 17, 2007 - link

    But water cooling has never been about the best price for the buck. The same can be said of any high end parts. Extreme intel, amd FX, 8800gtx, SLI, none of this makes sense for the price you pay.

    Water cooling falls right into that category. If you really want it to show it's teeth load up an 8800 SLI system, build a custom loop at the 300 and 500 price point, water cool everything, and then compare temps.

    Obviously it's going to cost a lot more, but this is a given.

    You're article seems to hint that air cooling is better then water cooling, this isn't the case at all. All it shows is that high end air cooling is a better value then a water cooling kit designed for a novice on a budget.

    As for "might" and 300, that's wrong as well. My apogee gt + lian DDC, + mcr 220 2x yate loons push, pentosion did drop my temps over a tuniqu tower. The water blocks on the 8800's with an mcr 320 moved even more hot air out of my case and temps dropped more. That CPU loop costs less then 300.

    So, DDC pump $65, mcr 220 45, apogee gt 45, and about 30 bucks for fans, tubing and anti corrosive. Brings you to about 200, hardly the 300.
  • EODetroit - Monday, September 17, 2007 - link

    Next time water cool the video card as well, and compare it against the CPU and video card on Air. OC both the video card and CPU and see how far they go. Then measure system noise. I agree with your conclusion that if you're only going to water cool your CPU, that you might as well go with a new air cool instead. But the CPU isn't the only expensive, hot, noisy thing in the case. In fact, the GPU is for many or most of us more expensive, hotter, and noisier.

    You shouldn't pretend the GPU isn't there. Water cool it as well and compare it THEN against air cooling.
  • Lonyo - Monday, September 17, 2007 - link

    You forgot another element of one of your watercooling setups.
    It's external.

    PLEASE PLEASE PLEASE try looking at other temperatures, e.g. graphics card, motherboard, HDD, when doing these tests.
    The heat has to go somewhere. With an air cooler it stays inside the case before passing by the graphics card and getting pushed out the back of the case.
    With an external watercooling setup it gets transferred outside without going over the graphics card/motherboard, and hence internally other components beside the CPU should in theory be cooler.

    My view is that the main advantage of watercooling is the low CPU temps combined with lower internal case temps, since I wouldn't think of running water with an internal radiator.
  • Nickel020 - Monday, September 17, 2007 - link

    I don't understand how you reached the conclusion, that good air cooling is better than sub 300$ water cooling by testing two sub 150$ water cooling kits.
    I have recently upgrade from a lapped Scythe Infinity to a 300$ wattercooling setup and at a maximum fan speed of ~1300 rpm (two fans dual radiator) the watercooling beats air by 10K but is little bit noisier since the fans sit at the top of the case. At 7V it's less noisier than the Infinity and still about 5K cooler.

    Please test a real 200+$ watercooling setup before drawing such conclusions. The test clearly shows that cheapw atercooling isn't worth it, but starting at about 200$ watercooling will beat air cooling if you choose good components.
    Here's a link to jstu about the ebst setup for 250$:

    http://www.petrastechshop.com/pecoel.html">http://www.petrastechshop.com/pecoel.html

    The waterblock is one of the ebst available, the Swiftech radiators are great for the price and with a modded top the Laing pupm is very quiet and has a excellent performance.

    I'd very much like to see Anandtech finally review some proper water cooling!

    PS: The review is otherwise very nice, finally a good review that compares low end watercooling with top-end air cooling.
  • poohbear - Monday, September 17, 2007 - link

    quote:

    Please test a real 200+$ watercooling setup before drawing such conclusions. The test clearly shows that cheapw atercooling isn't worth it, but starting at about 200$ watercooling will beat air cooling if you choose good components.
    Here's a link to jstu about the ebst setup for 250$:

    http://www.petrastechshop.com/pecoel.html">http://www.petrastechshop.com/pecoel.html


    dude, that link shows it's $250!!! i can get the thermalright 120 extreme for $65... the choice seems like an absolute no brainer to most.
  • retrospooty - Monday, September 17, 2007 - link

    "'d very much like to see Anandtech finally review some proper water cooling!

    PS: The review is otherwise very nice, finally a good review that compares low end watercooling with top-end air cooling."



    Agreed. It would be great to see a full review, including a few high end kits, cooling graphics cards as well, since that IS how they are used.

    This is a high end "best of the best" air cooler against 2 low end "mediocre" water kits.
  • Wesley Fink - Monday, September 17, 2007 - link

    We have also tested two kits closer to $300 in price from top water cooler manufacturers and they did not beat our top air cooler results. The Infinity was not a top performer in our test results unless it was driving a dual push-pull fan configuration. Stock it was slighly worse than the two water coolers we tested in this review.

    Also, Intel, Swiftech, Thermalright and others have now found that a convex base improves cooling performance mounted to current Intel CPU caps which are manufactured not flat to improve cooling performance. Lapping your Infinity prbably did no harm but lapping a thermalright would likely decrease performance. Swiftech in the past was a strong advocate of flat mirro-finish bases, but they now use the intentionally bowed plate on their top water blocks to improve cooling and overclocking.
  • Nickel020 - Monday, September 17, 2007 - link

    Well the problem with watercoolig is that no big manufacturer offers a good kit, you absolutely need to mix and match parts from different manufacturers.
    Go to the forums here or at xtremesystems.org and everybody will confirm that a *well chosen* 300$ watercooling will beat any air cooling. You just need the right components, like in the ones in that kit.

    And I know about the lapping/bowing, I lapped my CPU as well and got a 13K lower temperature with both lapped than before. A bowed cooller usually has the advantage since almost all heatspreaders are concave, therefore a convex cooler is needed to make a good contact. But if you lap both CPU and cooler you're usually better off if you do it right.

    I would love to see you review a watercooling setup with good components, there almost no reviews on the net comparing good watercooling to top-end aircooling.
  • yyrkoon - Monday, September 17, 2007 - link

    quote:

    The multiple liquid-filled heatpipes and the large, quiet, high-output fans in use today have taken air cooling to new performance levels. Our testing here at AnandTech supports the vastly superior performance of the heatpipe tower compared to the older air cooling designs. With these results in mind, it is time to revisit the question: is water cooling still the best performer?


    I think the real questions are . . . is it really worth the Hassle/danger/cost.

    Even a $300usd water cooling system is not a good water cooling system, and one that uses less than 1/2 tubing/waterbloccks etc, is not a good water cooling setup.

    Anyhow, I am not an advocate of water cooling, and I have been saying air is better than water for a long time now (couple of years), not because of cooling performance alone, but because of the three things mentioned above . . .Hassle/danger(or risk if you like)/costs. Building a top notch cooling system would set you back about $400 a year ago, now, probably more like $500-$600, but I wouldnt know for a fact, beause water cooling for PCs is like 4x4's with a 128 inch lift kit, its made to compensate for something, perhaps a small . . . CPU( or more likely something else) ?
  • poohbear - Monday, September 17, 2007 - link

    well i'll be damed, i never considered watercooling cause it was too exotic and expensive, but it seems there's no point considering it to begin w! the best aircoolers are quieter AND run cooler than watercooling. Thanks for showing this fantabulous change of events anandtech.

Log in

Don't have an account? Sign up now